Sliding Door Installation - tayco Cosmo Installation Manual

sliding door installation

1. Remove the top bracket from the
sliding door vertical post and
insert the vertical post cap into
the vertical post, (Figure 1).
2. Remove the top trim and the
plastic connector on one side of
the top trim on the frame where
the sliding door is going to be
installed, (Figure 2).
3. Position the vertical post at the
edge of the frame and screw it to
the frame with six 1-inch self
tapping screws, (Figure 3);
Figure 4 shows which holes in
the frame are to be used.
MARCH 2017
FIGURE 1
TOP BRACKET
VERTICAL POST
FIGURE 2
FIGURE 3
VERTICAL POST
VERTICAL POST CAP
TOP TRIM
FIGURE 4
SELF TAPPING
SCREW
cosmopolitan 42