Table of Contents
Advertisement
surface level access door installation
1. The access door tile will be
pre-assembled by Tayco, prior to
shipping.
2. On the panel frame there are two
pilot holes starting at 31
3/4-inches. Install the self
tapping Robertson screws #8,
3/8-inch with washer provided
through the access door plate
into the panel frame, adjust
vertically and horizontally to line
up with upper tiles and then
tighten, (Figure 1). Slide the
door down to close and verify if
any other adjustments are
required, (Figure 2).
MARCH 2017
FIGURE 1
FIGURE 2
ACCESS DOOR
#8 3/8-INCH
SELF-TAPPING SCREW
drill
#3 Robertson bit
tools & hardware needed
4, #8 3/8" self
4,
1/2" washer
tap screw
cosmopolitan 63
Advertisement
Table of Contents
