Table of Contents
Advertisement
worksurface support installation -
cantilever & bracket
1. Distribute all suports (cantilever
and bracket) at their proper
location.
2. Measure from the bottom of the
panel frame up to 27-inches in
height or count the slotted frame
channel (23 in total), (Figure 1).
3. Insert the cantilever support by
angling it at 30 degrees; place
the support hook into the slotted
frame channel, release it down
and the support will be engaged,
(Figure 2). There are two types
of cantilever supports: one that
joins two surfaces together
(intermediate cantilever support),
and the other one is for end runs,
and it can be left and right sided,
(Figure 3).
MARCH 2017
FIGURE 1
27-
INCHES
FIGURE 2
FIGURE 3
27-
INCHES
cosmopolitan 69
Advertisement
Table of Contents
