Worksurface Support Installation - End Gable - tayco Cosmo Installation Manual

worksurface support installation - end gable

End gables are attached to panel
frames with end gable brackets (two
per end gable) that come in left or
right.
1. Measure up to 24-inches in
height from the bottom of the
panel for the upper gable
bracket. The lower gable
bracket is to measure from the
bottom of the panel up to 8
inches.
2. Insert the end gable brackets by
angling them at 30 degrees;
place the gable bracket hook into
the slotted frame channel,
release it down and the gable
brackets will be engaged,
(Figure 1).
3. Attach two 90-degree brackets to
the gable, with four, 11/16-inch
oval head screws using #2
Robertson bit, (Figure 2).
MARCH 2017
FIGURE 1
24-INCHES
8-INCHES
FIGURE 2
END GABLE
BRACKET
4 1/2-INCHES
90-DEG
BRACKET
4 1/2-INCHES
END GABLE
cosmopolitan 71