Table of Contents
Advertisement
end gable pedestal installation
End gables pedestal are attached to
panel frames with end gable
brackets (two per end gable) that
come in left or right.
1. Measure up to 24-inches in
height from the bottom of the
panel for the upper gable
bracket. The lower gable
bracket is to measure from the
bottom of the panel up to
8-inches, (Figure 1).
2. Insert the end gable brackets by
angling them at 30 degrees;
place the gable bracket hook into
the slotted frame channel,
release it down and the gable
brackets will be engaged,
(Figure 2).
3. Remove drawers from pedestal
by disengaging the safety lock
located at the sides of the
drawer, (Figure 3).
4. Position the gable pedestal into
place; level and adjust glides if
necessary.
5. Attach the gable pedestal to the
gable brackets on the panel with
four, 11/16-inch oval head
screws, using #2 Robertson bit,
(Figure 4).
MARCH 2017
FIGURE 1
24-INCHES
8-INCHES
FIGURE 2
FIGURE 3
FIGURE 4
END GABLE
BRACKETS
cosmopolitan 76
Advertisement
Table of Contents
