Table of Contents
Advertisement
panel assembly - "T" configuration (cont'd)
3. Remove the tiles on one side of
each panel.
4. Rotate one panel to create a
90-degree angle.
5. Using a 6-inches hex key, install
the 25 mm or 1-inch hex screws
into the inside edge of the panels;
this will protrude into the
"T"-CONNECTORS, (Figure 3).
6. For the third panel follow the
same procedures as stated
above.
7. Insert between connectors pieces
of 2 1/2-inches diameter sponge
vertically, so that light will not
protrude through, (Figure 3).
8. Re-install the tiles previously
removed, if there is no panel to
install next to it.
NOTES:
> Do not re-install the tiles right
away, might need them off to
install next frames.
> Sponge to be inserted before last
panel is installed.
MARCH 2017
FIGURE 3
2 1/2-INCHES
SPONGE
TOP VIEW
25mm HEX
SCREW
panel height (inches)
T connector
25mm hex screw
37
45
2X
3X
12X
18X
torpedo level
drill
"T"-CONNECTOR
25mm HEX
SCREW
2 1/2-INCHES
SPONGE
hardware needed
53
61
69
77
85
3X
3X
3X
3X
4X
18X
18X
18X
18X
24X
tools needed
6" hex key
box wrench
cosmopolitan 20
Advertisement
Table of Contents
