Table of Contents
Advertisement
1. Make sure door is closed before
starting installation, attach the
corresponding filler connectors
to the side of the door, with 25
mm or 1-inch hex screws,
(Figure 1).
2. Remove all the tiles on one side
of the panel and line up to the
top of the door frame with the
existing panels, either to the left
or to the right.
3. Using a 6-inches hex key, insert
the 25 mm or 1-inch hex screws
into the holes on the edge of the
frame, from the inside; the
screws will protrude into the
connectors, (Figure 2). Follow
the instructions of the frame
assembly for the other
configurations.
4. Step on the metal threshold bar
to level off with the floor.
MARCH 2017
FIGURE 1
FIGURE 2
PANEL
FRAME
FILLER
CONNECTOR
METAL
THRESHOLD BAR
PANEL DOOR
FRAME
PLAN VIEW
cosmopolitan 38
Advertisement
Table of Contents
