Table of Contents
Advertisement
panel top mounted glaze installation (cont'd)
5. Check the base extrusion if it is
straight, (Figure 5). Overtighten
set screws will bend the base
extrusion outward and end caps will
not fit.
6. Place the end cap on both ends of
the base extrusion then push it
down to secure, (Figure 6).
MARCH 2017
FIGURE 5
CORRECT
SIDE VIEW
FIGURE 6
drill
GLASS/ACRYLIC
BASE EXTRUSION
SET SCREW
TOP TRIM
PANEL
END CAP
BASE EXTRUSION
allen key
#2 Robertson bit
NOT CORRECT
tools & hardware needed
#10-1x 1/2" self
1/4-20 x 1/4"
set screws
drilling screw
cosmopolitan 93
Advertisement
Table of Contents
