Mitel MIVOICE OFFICE 400 User Manual page 127

The ISED label identifies certified equipment. This certification means that
the equipment meets certain telecommunications network protective, oper-
ational, and safety requirements. ISED does not guarantee the equipment
will operate to the user's satisfaction. The ISED Certification number is
Mitel 470
Before installing this equipment, users should ensure that it is permissible
to be connected to the facilities of the local telecommunications company.
The equipment must also be installed using an approved method of con-
nection. The customer should be aware that compliance with the above
conditions may not prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian
maintenance facility designated by the supplier. Any repairs or alterations
made by the user to this equipment, or equipment malfunctions, may give
the telecommunications company cause to request the user to disconnect
the equipment.
Users should ensure for their own protection that the electrical ground con-
nections of the power utility, telephone lines, and internal metallic water
pipe system, if present, are connected together. This precaution may be
particularly important in rural areas.
The Ringer Equivalence Number (REN) indicates the maximum number of
devices allowed to be connected to a telephone interface. The termination
on an interface may consist of any combination of devices subject only to
the requirement that the sum of the Ringer Equivalence Numbers of all the
devices does not exceed 5.
The Ringer Equivalence Number is 0.1.
There are no user serviceable parts within this equipment. Refer all servic-
ing to a MITEL authorized repair facility or to MITEL Corporation. If you
require a MITEL return authorization number, or information on obtaining
service or repairs, please contact MITEL at the following telephone num-
ber:
1-800-SXMITEL (1-800-796-4835)
Mitel 6873 SIP
eud-1744/1.4 – R5.0 HF2 – 10.2017
IC: 173A-M470RFA
CAUTION!
Users should not attempt to make such connections themselves, but
should contact the appropriate electric inspection authority, or electri-
cian, as appropriate.
Product and safety information, legal information
127