Dtmf And Dial Tone Circuit Setup - NEC Electra Elite IPK II Programming Manual

Electra Elite IPK II
Program 10 : System Configuration Setup
Level:
IN
Description
Use Program 10-09 : DTMF and Dial Tone Circuit Setup to allocate the circuits on
the CPUII for either DTMF receiving or dial tone detection. The CPUII has 16 circuits
initially. On the Electra Elite IPK II, with additional PGD(2)-U10 ADPs installed, the
system can provide a total of 64 circuits (32 + 32). These are used as follows:
J
J
Input Data
Feature Cross Reference
J
J
J
J
J
Electra Elite IPK II Programming Manual

10-09 : DTMF and Dial Tone Circuit Setup

Extension DTMF receiver for single line telephone
Trunk DTMF receiver for analog trunks, dial tone & busy tone detection
for analog trunks
Circuit/Resource Number
Item
Input Data
No.
01 0 = Common Use
1 = Extension Only
2 = Trunk Only
Conditions
None
Caller ID
Central Office Calls, Placing
Direct Inward Dialing (DID)
Direct Inward System Access (DISA)
Tie Lines
Default Setting
Circuit/Resource 01-08: 1 (Extension Only)
Circuit/Resource 09-32: 2 (Trunk Only)
Circuit/Resource 33-64: 0 (Common Use)
Document Revision 1
01~64
2 - 17