NEC Electra Elite IPK II Programming Manual page 237

Document Revision 1
Input Data
2 - 202
Item
Item
No.
08 Preset Dial Display Hold Time
09 Ringdown Extension Timer (Hotline
Start)
A Ringdown extension automatically
calls its programmed destination after
this interval.
10
Dial Digits for Toll Restriction Path
If this option is programmed with an
entry other than "0", a call will not
have a talk path unless the user dials
at least the number of digits entered in
this option when placing an outgoing
call.
This means that an entry of 4 or
higher in this program will cause a
problem when dialing 911. Since it is
only a 3-digit number, the call will not
have a talk path, preventing the
emergency dispatcher from hearing
the caller. It is recommended that this
option be kept at its default setting of
"0" to prevent any problems with
dialing 911.
11 Inter-Digit Time for Toll Restriction
Path Control
12 Dial E911 Routing Without Trunk
Access
If enabled (1), an extension user can
dial 911 without first dialing a trunk
access code or pressing a line key. If
disabled (0), an extension user must
dial a trunk access code (e.g., 9) or
press a line key before dialing 911.
13 Alarm Ring Timer (E911)
Use this option to set the duration of
the E911 Alarm Ring Time. If set for 0,
the E911 Alarm will not ring.
14 Forced Account Code Inter-digit
Timer
The system waits this interval for a
user to enter a Forced Account code.
15
Outgoing Disable on Incoming Line
(Toll Restriction)
Enable or disable the Outgoing
Disable on Incoming Line feature.
Electra Elite IPK II
Input Data Default
0~64800 (sec)
10
0~64800 (sec)
0~24
0~60
0 = Trunk
Access
Code
Required
1 = Trunk
Access
Code Not
Required
0, 1~64800 (sec)
(0 = Off)
0~64800 (sec)
0 = Disable
(Off)
1 = Enable (On)
Program 21 : Outgoing Call Setup
Related
Program
5 20-08-09
21-11
0
0
1
0 11-12-56
20-08-16
3
0 15-01-05
21-01-16
21-01-17