How To Enter Programming Mode - NEC Electra Elite IPK II Programming Manual

Document Revision 1
Feature Cross Reference provides you with a table of all the features affected by the
program. You will want to keep the referenced features in mind when you change a
program. Customizing a feature may have an effect on another feature that you did
not intend.
Telephone Programming Instructions shows how to enter the program data into
system memory. For example:
1.
2.
H
S 3
OW TO
ECTION
To enter programming mode:
1.
2.
3.
4.
5.
1 - 2
Enter the programming mode.
15-07-01
15-07-01 TEL
KY01 = *01
←
tells you to enter the programming mode, dial 150701 from the telephone dial
pad. After you do, you will see the message "15-07-01 TEL" on the first line of
the telephone display. This indicates the program number (15-07), item number
(01), and that the options are being set for the extension . The second row of the
display "KY01 = *01" indicates that Key 01 is being programmed with the entry
of *01. The third row allows you to move the cursor to the left or right, depending
on which arrow is pressed. To learn how to enter the programming mode, refer
to Section 3 How to Enter Programming Mode
E P
NTER ROGRAMMING
Go to any working display telephone.
In a newly installed system, use extension (port 1).

Do not lift the handset.
Press Speaker.
.
# #
, ,
Password
Dial the system password + Transfer.
Refer to the following table for the default system passwords. To change the
passwords, use 90-02 : Programming Password
→
M
ODE
Electra Elite IPK II
below.
Setup.
Introduction