Setup Procedure - NEC Thin Client US310e Getting Started

Setup procedure

This guide describes the procedures from removing the thin client from its box to getting
it ready for use. Perform these procedures according to the instructions in this guide.
* When UWF is enabled, the settings specified in Steps 6 to 8 are lost after the terminal is
restarted. (In US310e, UWF is enabled by default.)
Step 1 Check the accessory box
 
US310e AC adapter
 
Getting Started (this document) End user license

DVI-VGA adapter
Step 2 Install US310e
Decide where to locate US310e.
For details, see Chapter 1, "3. Installation and Connection" in the User's Guide.
Step 3 Connect the cables
Connect cables to US310e.
For details, see Chapter 1, "3. Installation and Connection" in the User's Guide.
Front view
Microphone
Headphones and
computer speakers
USB devices
Rear view
Display
(DVI or VGA)*1
Display
(DVI)
USB devices
*2
AC adapter
*1. Use the supplied DVI-VGA adapter to connect a display that uses a VGA interface.
*2. The USB 3.0 port is disabled by the factory default settings.
Step 4 Turn on US310e
Press the power switch to turn on US310e.
Power switch
Hub
(multi-port repeater)