Panasonic MINAS A4P Series Instruction Manual page 93

16-Bit Positioning Parameter
16-bit positioning parameter can be set.
<Notice>
Select an input digit (a dot blinks) by the [SHIFT] key and a parameter by the [UP]/[DOWN] key.
When you press the [SET] key, the parameter is modified.
* When you press
display is shown again.
* When you have set the parameters, write the parameters into EEPROM. If you turn the power supply
off before writing the parameters into EEPROM, those parameters are cleared.
Press
.....16.Pr00
.....16.Pr01
.....16.Pr63
A parameter that " " is displayed on this position is enabled
after writing a set value in EEPROM and resetting the system.
during parameter setting, any parameter in process is not changed and "No."
.
[Setting]
Selected 16.PrNo.
93