Panasonic MINAS A4P Series Instruction Manual page 102

How to Use the Console
Copying of Parameters from the Console to the Driver
Operation at SELECTION display
Starting from initial LED status,Press
to make a display to
Operation at EXECUTION display
Press to call for
EXECUTION DISPLAY of
Keep pressing until
the console display (LED)
change.
Check whether or not to
transfer the read parameter
to the servo driver.
The positioning parameter is
copied from the console into the
servo driver.
The servo parameter is copied
from the console into the servo
driver and the driver type code of
the servo parameter is written into
EEPROM (console).
When you have finished the copy, press
<Remarks>
Don't disconnect the console from the driver between
Should the connector is pulled out, insert it again and repeat the procedures from the beginning.
<Note>
If the error display repeats frequently, check the broken cable, disconnection of the connector,
misoperation due to noise or failure of console.
102
six time after pressing
If a type code stored in EEPROM (console)
and another type code of servo driver are
different from each other.
When you keep on pressing
a dot ( ) moves to the left.
Copying completes normally.
To move to the next process, press
to return to
, then press
" " increases by
pressing (approx. 3sec)
as the left fig. shows.
Press
.
.
SELECTION display
to
.
,
Error display
<Remarks>
If error is displayed,
repeat the procedures
from the beginning.
.