Module Control; Control Categories; Figure 5-1: Navigation Tree; Figure 5-2: High Level Card Controls - evertz MultiFrame 7814 Series User Manual

5.

MODULE CONTROL

The 7814 series of products are controlled using VistaLINK
Ethernet and SNMP control protocols. The 7814 series modules DO NOT HAVE card edge controls. As a
result, 7700FC/7800FC modules must be installed in all frames that house 7814 series modules. Refer to
the Evertz website for the most recent firmware for the 7700FC/7800FC. When using VistaLINK
is also important to ensure that the most recent 7814 series ".JAR" control file is installed. Refer to the
Evertz website for the most recent 7814 series ".JAR" file.
For the sake of brevity, the following sections describe module controls in terms of the parameters found
within the VLPRO screens for the 7814UDX-AES8-3G-2+UMX2+ICL2+IG2. The vast majority of controls
are the same for the UC, the XC and HDC versions of 7814 series modules. Exceptions to this are
outlined in section 1.2 of this manual. As additional features and options are released, additional sections
will be appended to this manual to show those control screens.
5.1.

CONTROL CATEGORIES

Within VistaLINK the 7814UDX-AES8-3G-2+ICL2+UMX2+IG2 series of products have a set of high level
®
card controls and a set of individual controls for each of the two processing paths. Refer to Figure 5-1
below to see an example of how these controls are initially presented within VistaLINK
To access the high-level card controls, select the card that you wish to access (i.e. 7814UDX-AES8-3G-
2+ICL2+UMX2+IG2 as shown above) and right click using your mouse and select "View Configuration".
The following six control tabs will appear as shown in Figure 5-2.

Figure 5-1: Navigation Tree

Figure 5-2: High Level Card Controls

Revision 1.1.3
7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Pro. VistaLINK
®
PRO operates using
®
PRO it
®
.
®
Page - 21