Table of Contents
Advertisement
7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
7.11. AFD ARC CONTROLS
The AFD ARC control tab is the key section that enables the user to define the automatic steering of
Aspect Ratio Conversions in response to incoming AFD codes. For each incoming AFD code, the user
may specify a unique ARC/Scaler operating mode and a unique output AFD code. In this way, incoming
AFD codes are effectively treated as "virtual GPIs" that recall scaler specific card presets.
To properly configure the 7814 series cards for AFD, proceed to the AFD ARC control tab. Select an AFD
code using the AFD Select drop down menu. This corresponds to the inbound AFD value for which you
will define a specific ARC/Scaler response. In the Conversion section, select the specific ARC processing
that you would like to occur every time that specified input side AFD code is received. Furthermore,
specify the outbound AFD code in the AFD stamp section. Note that the AFD Stamp control is enabled
only when the AFD Stamp Source is set to User AFD Stamp. Once all settings are selected, press the
Apply button on the top of the control tab. Perform this process for each incoming AFD value.
Figure 7-14: AFD ARC Tab
Page - 65
Revision 1.1.3
Hide quick links:
Advertisement
Table of Contents
