Afd Present Traps - evertz MultiFrame 7814 Series User Manual

7.7.1.5. SMPTE2016-1 Output Enable Control
This control enables and disables the insertion of AFD packets in the outgoing video signal.
Disable
Enable
7.7.1.6. SMPTE2016-1 Output Line
This control defines the line on which AFD packets will be inserted into the outgoing video signal when
AFD packet insertion is enabled. The user can set the output line using the AFD Output Line slider. Drag
the slider right to increase the value or move it left to decrease the value of the AFD Output line. The valid
range is from 7 to 24 with a default of line 9.
7.7.1.7. SMPTE2016-1 Bar Output Enable
This control Enables/Disables Bar Data on the output video. Bar data is used with AFD in order to
indicate the exact image size if not exactly 16:9 or 4:3. The following image depicts the drop down menu
with the available controls.
Disable When set to disable, Bar Data will not be inserted in to the output video
Enable When set to Enable, Bar data will accompany the AFD information in the output picture.
When set to Auto, the card will automatically respond to the current card configuration and
Auto
insert bar data as needed.

7.7.2. AFD Present Traps

To enable a specific Fault trap, click the small box beside the relevant fault and ensure that a check mark
appears in the box. To disable a specific Fault trap, click the small box beside the relevant fault and
ensure that a check mark does not appear in the box.
AFD codes will NOT be inserted into the outgoing video signal.
AFD codes will be inserted into the outgoing video signal.
Revision 1.1.3
7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Page - 57