Gpio Connector; Table 2-1: Gpio Connector Pin Out - evertz MultiFrame 7814 Series User Manual

2.3.

GPIO CONNECTOR

There are 8 General Purpose Inputs/Outputs (GPIOs) on the 7814 series modules. Each GPIO may be
configured to be an input or configured to be an output. These GPIOs are interfaced using a 15-pin DB
connector and an associated breakout cable (cable part # WPAES8-DINM-9W-6F). NOTE: The GPIO
breakout cable is not included with the module when purchased. Table 2-1 shows the Pin-out of this
connector is as follows:
DB-15
Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Shell
GPIO DB CONNECTOR
Name Description
GPIO1 General Purpose Input /Output #1
LTC Tx (not
External LTC Out
used)
GPIO2 General Purpose Input /Output #2
GPIO4 General Purpose Input /Output #4
6 Hz in (not
External 6 Hz In
used)
LTC Rx External LTC IN 1
Metadata Tx Metadata Out
GPIO3 General Purpose Input /Output #3
GPIO8 General Purpose Input /Output #8
Metadata Rx Metadata In
GPIO5 General Purpose Input /Output #5
GPIO6 General Purpose Input /Output #6
Metadata Tx Metadata Out
GPIO7 General Purpose Input /Output #7
Metadata Rx Metadata In
GND Ground

Table 2-1: GPIO Connector Pin out

Revision 1.1.3
7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Colour
Red
Green
Blue
Purple
Orange
White
A2 DIN PIN
Yellow
- -
- -
A1 DIN PIN
- -
- -
A4 DIN PIN
A3 DIN PIN
- -
Page - 13