Table of Contents
Advertisement
7.1.2. Video Monitor
The Video Monitor section enables the user to view the status of video related parameters. The following
sections describe the monitoring in detail.
7.1.2.1.
PGM IN A Video Standard
The PGM IN A DIN Video Std reports if a valid video signal is presented to PGM IN A and what standard
has been detected when it is present.
7.1.2.2.
PGM IN B Video Standard
PGM IN B DIN Video Std reports if a valid video signal is presented to PGM IN B and what standard has
been detected when it is present.
7.1.2.3.
Input Video BNC
Input Video DIN reports what input DIN has been selected to pass through the main up/down/cross
conversion path.
7.1.2.4.
Video Delay
Video Delay reports video delay through the card in ms.
7.1.2.5.
Video Payload ID
Video Payload ID reports if a valid Video Payload ID ANC packet has been detected and will display the
decoded video format information.
7.1.3. Video Traps
To enable a specific Fault trap, click the small box beside the relevant fault and ensure that a check mark
appears in the box. To disable a specific Fault trap, click the small box beside the relevant fault and
ensure that a check mark does not appear in the box.
7800/7700 MultiFrame Manual
7814 Series Dual HDTV Up/Down/Cross Converters
Revision 1.1.3
Page - 43
Hide quick links:
Advertisement
Table of Contents
