Sbus Card; Removing An Sbus Card - Sun Microsystems Ultra 2 series Service Manual

10.3

SBus Card

To remove and replace the SBus card, proceed as follows.
Note –
representative of a system unit or sever chassis.
10.3.1

Removing an SBus Card

1. Power off the system unit.
See Section 6.2 "Powering Off the System Unit" on page 6-2.
2. Disconnect all cables from the SBus slots.
3. Remove the system unit cover.
See Section 7.1 "Removing the System Unit Cover" on page 7-1.
Caution –
an antistatic wrist strap and use an ESD-protected mat. Store ESD-sensitive
components in antistatic bags before placing it on any surface.
4. Attach the wrist strap.
See Section 7.2 "Attaching the Wrist Strap" on page 7-3.
5. Unlock the card retainers at the back edge of the SBus card by pushing the card
retainers back from the edge of the SBus card (
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Illustrations supporting the SBus card removal and replacement are not
Use proper ESD grounding techniques when handling components. Wear
).
FIGURE 10-4