Act Net Bus - Carrier TruVu VAVB3-E2 Installation And Startup Manual

Adjusting the TV-VAVB3-E2 driver properties

Act Net Bus

Act Net Bus Status
An Act Net device that is physically connected to the TV-VAVB3-E2 is automatically identified and the serial
number and current status are displayed on the Act Net Bus page.
NOTE You can edit the address and description on this page. Applying changes can take up to 20 seconds to
complete.
Act Net Bus Status
Device Address
Device Description
Serial Number
Device Status
Act Net Bus Configuration
Current Address
Device Description
Serial Number
New Device Address
TruVu™ VAVB3-E2
Installation and Start-up Guide
This table shows devices connected to the Act Net port. All fields are read-only.
Act Net device address (1 to 5). The same address is used as exp# in the
microblock configuration with the input/output number for all Act Net devices set
to 1.
This text is editable in the Act Net Bus Configuration table directly below.
The serial number of the Act Net device. This number is printed on a label on the
device.
Displays the current status of the device
Possible statuses Description
Normal Operation Successful communication
No Communication with TV-VAVB3-E2 has lost communication with the Act Net
the device device
Duplicate Address on More than one device has the same Device Address.
the network
Unsupported Device Device is not recognized
Type
Act Net Wiring Error Loopback error on Act Net bus, possibly caused by
wiring problem or hardware failure.
This table shows devices connected to the Act Net port. Most fields are editable.
Bus address of the Act Net device
Edit the name if needed.
Serial Number of the device corresponds to Current Address in the same row. This
field is read-only if the corresponding device is in communication, otherwise
becomes editable so that user can enter the serial number manually (can be found
as a label on the actuator).
Select a new bus address from the drop-down list.
84
CARRIER CORPORATION ©2022
All rights reserved