Carrier TruVu VAVB3-E2 Installation And Startup Manual page 98

To set up the controller through the Comm/Service ports
Local Devices table
Select
MAC
Serial#
Mode
Address
Location
Mismatch
Status
TruVu™ VAVB3-E2
Installation and Start-up Guide
Check to select devices for:
•
Changing the Mode
•
Resolving a Mismatch
•
Auto-assigning an IP Address
NOTE You cannot select devices with a lock symbol.
Ethernet MAC address of device
The discovered devices are in order by serial number.
NOTE To change how the rows are sorted, click a different column heading.
To change the Mode:
Select the devices you want to change.
1
Select one of the following IP addressing modes:
2
Default IP - Devices with rotary switches that are used when
○
autogenerating the address (if applicable)
Custom Static - A permanent IP addresses which does not change
○
and is usually obtained from the network administrator
NOTE Selecting this automatically sets the device's subnet and
○
default gateway to match the connected controller.
DHCP - Allows the DHCP server to automatically assign an IP
○
address
Click the Set button.
3
Displays the IP address of the device, if assigned. You can edit the address only
if the device is set to Custom Static.
To auto-assign multiple sequential addresses, select the devices, enter the
beginning address, and click Assign.
You can describe the location of the device or any other helpful information.
A Mismatch occurs when the connected controller's mode is set to Custom
Static and a discovered device's subnet and default gateway do not match the
connected controller. The incorrect addresses are shown with SN for subnet
and GW for default gateway.
To resolve a mismatch, select the device(s) by clicking the Select checkbox and
then clicking the Resolve button. The subnet mask and default gateway
addresses of the selected devices change to match the connected controller.
The following are the results of changing Mode, Address, Location, or pressing
Blink:
•
Success - Successful operation
•
No Response - Device is not communicating
•
Device Locked - Device must be unlocked before you can make any
changes using the Local Devices table. You can unlock the TV-VAVB3-E2 by
pressing the DSC button on the device or by using the i-Vu® application.
(See instructions above.)
NOTE The status of a device changes to locked 24 hours after unlocking it.
•
Failure - A conflict between the device and the information entered
92
CARRIER CORPORATION ©2022
All rights reserved