Wiring for power
Wiring for power
WARNING Do not apply line voltage (mains voltage) to the controller's ports and terminals.
CAUTIONS
•
The TV-VAVB3-E2 is powered by a Class 2 power source. Take appropriate isolation measures when mounting
it in a control panel where non-Class 2 circuits are present.
•
Carrier controllers can share a power supply as long as you:
•
Maintain the same polarity.
•
Use the power supply only for Carrier controllers.
To remove the TV-VAVB3-E2's cover
TIP To attach the cover to the base, secure a cable tie through the two cable tie brackets as shown below.
TruVu™ VAVB3-E2
Installation and Start-up Guide
14
CARRIER CORPORATION ©2022
All rights reserved