To Use The Locator Led - Carrier TruVu VAVB3-E2 Installation And Startup Manual

Troubleshooting
Color Pattern
Slow blink
Blue
Fast blink
Blue
Magenta

To use the Locator LED

The Locator LED turns on when you:
•
power on the controller
•
change the driver
•
Click the Blink button
TruVu™ VAVB3-E2
Installation and Start-up Guide
Condition
Linux (operating system) is
starting up
Linux is running but it could not
start the firmware application
Operating system changes are
downloading
WARNING This process could
take several minutes. Do NOT
power off the controller during the
download.
100
Message in Module
Status
N/A
N/A
N/A
Click the Blink button to prompt the Locator LED to
flash for 15 seconds, allowing you to verify the
controller's physical location. After flashing,
whenever the actuator moves, the LED rotates in
the same direction. LED rotation is automatically
disabled after 1 hour and can be re-enabled by
pressing the Blink button again.
The Blink button is in the:
•
controller setup Local Network tab > Local
Devices table
•
i-Vu® interface on the Driver page.
•
In the Test & Balance tool on the Test and
Balance tab.
CARRIER CORPORATION ©2022
Possible Solution
No action required
Download driver
No action required
All rights reserved