Field-Supplied Hardware - Carrier TruVu VAVB3-E2 Installation And Startup Manual

Field-supplied hardware

Each zone controller installation requires the following field-supplied components:
•
zone terminal unit
•
round or rectangular mounting bracket
•
space temperature sensor
•
supply air temperature sensor
•
2 x 4 in. standard single gang electrical box
•
power supply — 24 Vac, 50 VA or 24vdc 18W
•
two no. 10 x 1/2 in. sheet metal screws (to secure SAT sensor to duct)
•
two no. 6-32 x 5/8 in. screws (to mount space temperature sensor base to electrical box)
•
wiring
•
bushings (required when mounting SAT sensor in a duct 6-in. (15.2 cm) or less in diameter)
Optional:
•
contractors (if required for fan or electric heat)
•
indoor air quality sensor
•
relative humidity sensor
•
2 screws and 2 hollow wall anchors (to mount relative humidity sensor directly to wall)
•
valve and actuator for hot water heat (if required)
TruVu™ VAVB3-E2
Installation and Start-up Guide
11
What is the TV-VAVB3-E2?
CARRIER CORPORATION ©2022
All rights reserved