Fire-Lite Alarms MS-9200 Technical Manual page 91

Figure E-3: NFPA 72 Remote Station Protective Signaling System Figure E-3: NFPA 72 Remote Station Protective Signaling System Figure E-3: NFPA 72 Remote Station Protective Signaling System Figure E-3: NFPA 72 Remote Station Protective Signaling System Figure E-3: NFPA 72 Remote Station Protective Signaling System
Remote Station Connection Using RTM-8F Module Remote Station Connection Using RTM-8F Module
Remote Station Connection Using RTM-8F Module Remote Station Connection Using RTM-8F Module Remote Station Connection Using RTM-8F Module
Note: Cut Jumper JP-4 on MS-9200 System Board to supervise placement of the RTM-8F module..
Jumper JP2 must be in position
ALARM/TROUBLE REVERSE ALARM/TROUBLE REVERSE ALARM/TROUBLE REVERSE ALARM/TROUBLE REVERSE ALARM/TROUBLE REVERSE
POLARITY for use in alarm and POLARITY POLARITY
POLARITY POLARITY
trouble transmission or ALARM
ONLY ONLY ONLY for alarm transmission ONLY ONLY
only
JP2 Jumper Settings:
Alarm/Trouble Polarity
Reversal Remote Station
Alarm only Polarity
Reversal Remote Station
Note: Refer to Figure 2.4 and Section 2.5.1 for information on UL Power-limited wiring requirements.
Technical Manuals Online! - http://www.tech-man.com
Cut
JP1
ALARM ALARM ALARM ALARM
Document # 50428
firealarmresources.com
Fire-Lite RS82
Remote Station Receiver UL listed.
Refer to Fire-Lite Alarms, Inc., Instruction
Manual for Remote Station Receiver
Model RS-82.
RTM-8F Relay
Transmitter
Module
(not suitable for
transmission of
separate alarm
and trouble
signals to
Remote Station)
Power-limited
+ + + + +
- - - - -
Rev. B1 7/28/97 P/N 50428:B1
+ -
Polarity
Shown is
Normal Standby
91