Fire-Lite Alarms MS-9200 Technical Manual page 15

Accessories: R45-24E Remote Battery Charger Accessories: R45-24E Remote Battery Charger Accessories: R45-24E Remote Battery Charger Accessories: R45-24E Remote Battery Charger Accessories: R45-24E Remote Battery Charger
Fire•Lite Remote Battery Charger (R45-24E) Fire•Lite Remote Battery Charger (R45-24E)
The Fire•Lite Remote Battery Charger (R45-24E) Fire•Lite Remote Battery Charger (R45-24E) is Fire•Lite Remote Battery Charger (R45-24E)
capable of charging 20-55 amp-hour batteries. This
unit is required in a system using 25 amp hour or larger
batteries. The batteries and charger are housed in the
R45-24E cabinet, which can be mounted up to 20 feet
away from the control panel. To determine the battery
size needed in a particular system, see the Standby
Power Requirements in Appendix A.
CONNECTING THE PRIMARY POWER SOURCE CONNECTING THE PRIMARY POWER SOURCE CONNECTING THE PRIMARY POWER SOURCE CONNECTING THE PRIMARY POWER SOURCE CONNECTING THE PRIMARY POWER SOURCE
With the breaker at the main power distribution panel turned off, connect the primary Hot line to Terminal 1 on
the R45-24E and the primary Neutral line to Terminal 2. All connections between the MS-9200 and the R45-24E
must be made in conduit, using #14 AWG wire. Do not route 240 VAC wiring in the same conduit as other control
panel circuits. Leave the main power breaker off until installation of the entire system is complete.
CONNECTING THE SECONDARY POWER SOURCE CONNECTING THE SECONDARY POWER SOURCE
CONNECTING THE SECONDARY POWER SOURCE CONNECTING THE SECONDARY POWER SOURCE CONNECTING THE SECONDARY POWER SOURCE
Do not apply AC power or batteries until the system is completely wired and ready for testing. Refer to the Wiring
Diagram and Instructions for the R45-24E Charger (DWG. No. 1977-41 packaged with the R45-24E) for
additional information.
Remote Battery Charger Connection Remote Battery Charger Connection
Remote Battery Charger Connection Remote Battery Charger Connection Remote Battery Charger Connection
240 VAC, 50 Hz,
0.5 Amp Primary Power
Source
Hot Neutral
1 2
R45-24E
Note: Apply primary AC power to MS-9200 via standard transformer or with additional option transformer XRM-24E.
See Appendix A.
Technical Manuals Online! - http://www.tech-man.com
24 VDC (supervised). 24 VDC (supervised). 24 VDC (supervised). The maximum charge current for standby 24 VDC (supervised). 24 VDC (supervised).
batteries is 2 amps (fast charge) or 20mA (trickle charge). Use
#14 AWG wire in conduit (20 feet or less).
3 4
+ + + + + - - - - -
- + -
PS-12550
PS-12550
12 VDC
12 VDC
55-AH
55-AH
Battery Battery
Document # 50428
firealarmresources.com
+ - + -
+ - + - + -
+
- + - +
- + - + - +
Rev. B1 7/28/97 P/N 50428:B1
+ - + - + -
B + A + A - B - B + A + A - B - NO C NO NC C NO NC C
T T OPTION 1
T T T
PRINTER
B B B B
1 2 3 4 B
1 2 3 4 & UP/DOWN LOAD
4 2 1 5
3
J11
cut terminals from MS-9200
battery cable connected to J3
use wire nuts
2 A B B+ A+ B- A-
T
B
6
15