Fire-Lite Alarms MS-9200 Technical Manual page 49

The MS-9200 is completely field programmable, and requires no special software skills. Programming may
be accomplished in one of three ways:
• The Autoprogram feature - This method is very convenient for quickly bringing the system on-line or for
program editing.
• Manual Programming or editing, using the MS-9200 keypad.
• The Off Line Programming feature - This method allows creation of site-specific programs using a DOS-
based computer. For programs requiring a large amount of data entry, this method may be preferred. A
programming kit (PK-9200) may be ordered for this purpose.
When a programmed system is normal with no active alarms, troubles or supervisories, the 'SYSTEMS
ALL NORMAL' screen will be displayed as shown below:
In order to (1) program the system, (2) read system status, (3) print, (4) edit, or (5) walktest, the ENTER
key must first be pressed. After pressing ENTER, the screen shown below is displayed:
1 = Programming: Programming the system may only be accomplished by an authorized user. Before
attempting to program the system, place the SW1 Write Protect switch in the down position. SW1 is located
on the lower right side of the MS-9200 main circuit board (see page 6). If the switch is in the up 'Write
Protect' position while attempting to enter the Programming Mode, the LCD will display the following:
In order to program the system, a valid password must first be entered. Once the correct password is
entered, the user may select Autoprogram or Program Editing. After programming is completed, return SW1
to the Write Protect position.
Technical Manuals Online! - http://www.tech-man.com
III P III P III P
III P III P
R R R R R OGRAMMING OGRAMMING OGRAMMING OGRAMMING OGRAMMING
SYSTEMS ALL NORMAL
10:00 A MON 03/04/96
1=PROGRAMMING
2=RD STATUS 3=AC/BAT
WRITE PROTECT!!!
PRESS BACKSPACE
Document # 50428
firealarmresources.com
/R /R /R /R
/R
EAD EAD EAD EAD EAD
Rev. B1 7/28/97 P/N 50428:B1
S S S S S
T T T T T A A A A A TUS TUS TUS TUS TUS
49