Fire-Lite Alarms MS-9200 Technical Manual page 68

For software releases 73750 or greater, both NAC 1 and NAC 2 are programmable. Both NACs may be either
silenceable or nonsilenceable and may be programmed as steady or coded operations. Coded operation includes
March Time, Temporal or California types. Refer to Section 4.10 for additional information on coding.
4.7 4.7 4.7 4.7 4.7 Control-By-Event Operation Control-By-Event Operation Control-By-Event Operation Control-By-Event Operation Control-By-Event Operation
Each addressable detector and monitor module can be assigned to one software alarm zone. Control modules
may be assigned to a maximum of three software zones. A General alarm zone (Z00) may be listed for output
(control) points, but it is not necessary to list Z00 for input points, as this is the default zone. Z00 is not activated
by supervisory points.
When an input device (detector, M300 series modules) alarms and is not disabled, it activates all software
zones assigned to it. An output device (control module or Notification Appliance Circuit) that is not disabled is
turned on when any of the software zones to which it is mapped become active.
4.8 4.8 4.8 Detector Functions Detector Functions Detector Functions
4.8 4.8 Detector Functions Detector Functions
MAINTENANCE ALERT MAINTENANCE ALERT MAINTENANCE ALERT MAINTENANCE ALERT MAINTENANCE ALERT
Each detector is monitored by the control panel for its maintenance status. If a detector is within 80% of its alarm
threshold for a 24 hour period, a 'maintenance alert' message will be displayed automatically signaling that the
detector needs cleaning.
AUTOMATIC TEST OPERATION AUTOMATIC TEST OPERATION
AUTOMATIC TEST OPERATION AUTOMATIC TEST OPERATION AUTOMATIC TEST OPERATION
An automatic test of each detector is performed every two hours. The detector's sensing chamber and electronics
are functionally tested for normal, safe operation. A trouble message is displayed upon failure of this test. System
Reset clears this trouble.
TYPE CODE SUPERVISION TYPE CODE SUPERVISION TYPE CODE SUPERVISION TYPE CODE SUPERVISION TYPE CODE SUPERVISION
The MS-9200 monitors hardware device type codes (CP300, SD300, SD300T, M300, M301, M302, and C304) at slow
intervals. Mismatch of any type code, compared to the system program, will cause a device trouble.
SYSTEM ALARM VERIFICATION SYSTEM ALARM VERIFICATION SYSTEM ALARM VERIFICATION SYSTEM ALARM VERIFICATION SYSTEM ALARM VERIFICATION
The panel may be programmed to perform alarm verification. Alarm verification applies to detectors only. Refer to
Section 4.12 for a description of the Alarm Verification Timer.
4.9 4.9 4.9 Time Functions Time Functions Time Functions
4.9 4.9 Time Functions Time Functions
REAL TIME CLOCK OPERATION REAL TIME CLOCK OPERATION
REAL TIME CLOCK OPERATION REAL TIME CLOCK OPERATION REAL TIME CLOCK OPERATION
The MS-9200 includes a crystal time base clock that provides time of day, date, and day of week. Time is displayed
as 12 hour time with month/day/year, and is stored in RAM. If both AC and battery power are lost, the time must
be reset.
4.10 4.10 4.10 Coded Operation - Notification Appliance (Bell) Circuits 1 and 2 Coded Operation - Notification Appliance (Bell) Circuits 1 and 2 Coded Operation - Notification Appliance (Bell) Circuits 1 and 2
4.10 4.10 Coded Operation - Notification Appliance (Bell) Circuits 1 and 2 Coded Operation - Notification Appliance (Bell) Circuits 1 and 2
Shown below are the pulse rate outputs via NAC 1 or NAC 2 when coded operation is selected. Note that software
releases prior to P/N 73750 only allow coding on NAC 1. Releases 73750 or greater allow coded functions on both
NAC 1 and NAC 2.
CONTINUOUS CONTINUOUS NO PULSE CONTINUOUS CONTINUOUS CONTINUOUS
MARCH TIME PULSES AT 120PPM. MARCH TIME MARCH TIME MARCH TIME MARCH TIME
TEMPORAL CODE PULSES TEMPORAL CODE (0.5 sec. On, 0.5 sec. Off, 0.5 sec. On, 0.5 sec. Off, TEMPORAL CODE TEMPORAL CODE
TEMPORAL CODE TEMPORAL CODE
CALIFORNIA CODE 10 sec. On, 5 sec. Off CALIFORNIA CODE CALIFORNIA CODE CALIFORNIA CODE CALIFORNIA CODE
68
Technical Manuals Online! - http://www.tech-man.com
0.5 sec. On, 1.5 sec. Off).
Document # 50428 Rev. B1
firealarmresources.com
7/28/97 P/N 50428:B1