Fire-Lite Alarms MS-9200 Technical Manual page 41

2.15 2.15 2.15 2.15 2.15 Wir Wir Wir Wiring Detectors Wir
INSTALLATION INSTALLATION INSTALLATION
INSTALLATION INSTALLATION
• Connect the MS-9200 Communications SLC Loop to Terminal (-) and Terminal (+) of the removable
terminal block.
• If an RA400Z Remote LED Annunciator is being employed, connect the RA400Z positive terminal to the
RA+ terminal on the removable terminal block and the negative terminal to the RA(-) terminal on the
removable block.
• Before installing the appropriate addressable detector head, set the detector's address on the
head with a small slotted screwdriver. Mark this address on the head.
• Place the removable terminal block into the connector in the detector head. Be certain to align properly
and snap-in securely.
Figure 2.22: Wiring the Detector With Removable Plug-in Connector Figure 2.22: Wiring the Detector With Removable Plug-in Connector
Figure 2.22: Wiring the Detector With Removable Plug-in Connector Figure 2.22: Wiring the Detector With Removable Plug-in Connector Figure 2.22: Wiring the Detector With Removable Plug-in Connector
Technical Manuals Online! - http://www.tech-man.com
ing Detectors ing Detectors ing Detectors ing Detectors
Channel (+) Channel (+) Channel (+) Channel (+) Channel (+)
Communications
Channel ( - ) Channel ( - ) Channel ( - ) Channel ( - ) Channel ( - )
SLC Loop
Document # 50428
firealarmresources.com
4 5 4 5
3 3
6 6
2 2
7 7
1 1
8 8
0 0
9 9
SD300 with removable
plug-in connector
Rev. B1 7/28/97 P/N 50428:B1
Channel (+) Channel (+) Channel (+) Channel (+) Channel (+)
Channel ( - ) Channel ( - )
Channel ( - ) Channel ( - ) Channel ( - )
to next device
on Loop
- -
+ +
RA400Z Remote
LED Annunciator
41