Table of Contents
Advertisement
Patient Monitor User Manual
⑤ Freeze
⑥ Main
⑦ Trim Knob
Method to Use the Knob to Operate on the Screen:
The rectangular mark on the screen that moves with the rotation of the knob is called "cursor".
Operation can be performed at any position at which the cursor can stay.
When the cursor is in the waveform area, the user may immediately modify the current setup.
When the cursor is in the parameter area, the user may open the setup menu of the corresponding
parameter module so as to set up the menu items of the module.
Operating method:
Move the cursor to the item where the operation is required.
Press the knob.
One of the following four situations may appear:
1. The cursor with background color may become a frame without background color,
which implies that the content in the frame can change with the rotation of the knob.
2. Menu or measuring window may appear on the screen, or the original menu is
replaced by the new menu.
3. A check mark "
4. The system immediately executes a certain function.
In normal mode, press this button to freeze all the waveforms on the
screen. In FREEZE mode, press this button to restore the waveform
refreshing.
Press this button to return to the main interface.
The user can use the trim knob to select the menu item and modify
the setup. It can be rotated clockwise or anticlockwise and pressed.
The user can use the knob to realize the operations on the screen, in
the SYSTEM MENU and parameter menu.
√
" appears at the position, indicating that the item is confirmed.
- 17 -
Introduction
Advertisement
Table of Contents
