Table of Contents
Advertisement
Patient Monitor User Manual
Setting the SpO
upper alarm limit to 100% is equivalent to switching off the alarm on
2
upper limit. High oxygen levels may predispose a premature infant to retrolental
fibroplasia. Therefore, the upper alarm limit for oxygen saturation must be carefully
selected in accordance with commonly accepted clinical practices.
SpO
Alarm Setting
2
ALM: pick ON to enable prompt message during the SpO
the alarm function, and there will be a
In order to avoid endangering the patient's life, the user should use this function
cautiously.
ALM LEV: used to set up alarm level, selectable from HIGH, MED and LOW. HIGH
represents the most serious case.
ALM REC: pick ON to enable report printing upon SpO
SpO
alarm is activated when the result exceeds SpO
2
ALM LO value. Use the knob to pick the SpO
turn the knob to select the desired alarm limit.
PR alarm is activated when the pulse rate exceeds PR ALM HI value or falls below PR
ALM LO value. Use the knob to pick the PR ALM HI or PR ALM LOW item and turn the
knob to select the desired alarm limit.
SWEEP
Available options for SpO
PR SOUND
It indicates the Pulse beep volume. Options are "0 - 5".
PITCH TONE
When ON is enabled, the system will provide prompt sound with different tone for clinic
under complex monitoring environment, based on the variance of SpO
DEFAULT
Pick this item to access the SpO
select whether the FACTORY DEFAULT CONFIG or the USER DEFAULT CONFIG is
to be used. After selecting any of the items and exiting the dialog box, the system will pop up
the dialog box asking for the user's confirmation.
WARNING
WARNING
SWEEP are 6.25, 12.5, 25.0 and 50.0mm/s.
2
DEFAULT CONFIG dialog box, in which the user may
2
- 105 -
alarm; pick OFF to disable
2
besides "SpO
".
2
alarm.
2
ALM HI value or falls below SpO
2
ALM HI or SpO
2
2
SpO
Monitoring
2
ALM LOW item and
value.
2
2
Advertisement
Table of Contents
