EDAN iM8 Series User Manual page 24

Patient Monitor User Manual
to the actual requirement. Its range is described in the part: IBP Monitoring. In the IBP waveform
area, the waveform scale is displayed. The three dotted lines for each IBP waveform from up to
down represent respectively the upper limit scale, reference scale and lower limit scale. The
values of these three scales can be set. The specific method is given in the part: IBP Monitoring.
When a certain menu is displayed, some waveforms become invisible. Main display is restored
when you exit the menu.
The user may set up the rate to refresh the waveform. The method to adjust the refreshing rate of
each waveform is discussed in the setup description of each parameter.
Parameter Area(③)
Parameter area is on the right of Waveform area, and parameters are displayed corresponding to
waveforms basically. They are:
ECG:
⎯ Heart Rate (Unit: beats per minute, bpm)
⎯ ST-segment analysis of Channel 1 & 2-ST1, ST2 (Unit: mV)
⎯ PVCs (Premature Ventricular Contraction) events (Unit: event/min)
SpO :
2
⎯ Oxygen Saturation SpO
⎯ PR (Unit: BPM)
NIBP:
⎯ Systolic pressure, Mean pressure, Diastolic pressure (Unit: mmHg or kPa)
⎯ PR (NIBP) (Unit: BPM)
TEMP:
⎯ Temperatures of channel 1, channel 2 and their temperature difference: T1, T2, TD
(Unit:°C or °F)
RESP:
⎯ Respiration Rate (Unit: breath/min)
IBP:
⎯ The blood pressure of channel 1 and 2. From left to right, there are Systolic pressure,
Mean pressure and Diastolic pressure（Unit: mmHg or kPa)
CO :
2
⎯ EtCO
(Unit: %, mmHg or kPa)
2
⎯ FiCO
(Unit: %, mmHg or kPa)
2
⎯ AwRR (Unit: times/minute)
Alarm Indicator and Alarm Status
In normal status, the alarm indicator does not light.
When an alarm occurs, the alarm indicator will light or flash. The color of light represents the
alarm level. Refer to Chapter6 Alarm for details.
Refer to relative content of parameter for Alarm information and prompt.
(Unit: %)
2
- 15 -
Introduction