Table of Contents
Advertisement
Identifier
Meaning
The pump is in
The
The pump is in
The
A hose rupture indicator is connected.
The pump is in the
5.2.2 Key functions
Key
Application
[Back]
press
press
[STOP/
START]
[Menu]
press
[Priming]
press
[Clickwheel]
press
[Clickwheel] turn
'ANALOG' operating mode.
'Curve è linear' type of processing is set.
'ANALOG' operating mode.
'Curve è Upper side band' type of processing is set.
'Menu' (Set up).
In the continuous displays
-
Stop pump,
Start pump
Go to the menu
Priming *
Start batch (only in
mode),
Acknowledge errors
Switch between the continuous dis‐
plays
Overview of equipment and control elements
Further explanations can be found in the "Trouble‐
shooting" chapter.
The pump only shows the metering volume and the
capacity in the calibrated state in l or l/h or in gal or gal/h
(US gallons).
In the menu
Go back to the previous menu
item (or a continuous display) -
without saving
Stop pump,
Start pump
Go back to a continuous display
Priming *
'Batch' operating
Go to next menu item (or a contin‐
uous display)
Confirm entry and save
Change figure or change selection
CAUTION!
Rotor is running on
The rotor will continue to run on to 180° once the pump
has been stopped by the
–
Take this into account before working on the pump
or pipework.
[STOP/START] key.
21
Advertisement
Table of Contents
