Extron electronics Multi-Graphic Processor MGP 464 User Manual page 77

Command/response table for IP SIS commands (continued)
Command
Bi-directional serial data port (continued)
Configure mode 24
View mode
Configure flow control
24
View flow control
Configure receive timeout 24
X1&
N = Time in tens of milliseconds that the MGP will wait until receipt of the first response character before terminating the command. (Default = 10 = 10 ms; max. = 32767.)
X2)
= Time in tens of milliseconds that the MGP will wait between characters being received via a serial port before terminating the current command or receive operation.
(Default = 20 = 20 ms; max. = 32767.)
X2!
= #L or #D. The letter parameter is case sensitive (requires capital D or capital L). For
L = Length of the message to be received,
D = Delimiter value. A delimiter of ASCII 0A = 10D.
# = Byte count (for L) or a single ASCII character expressed in decimal form (for D).
Byte count # can be 0 through 32767; default = 0. The ASCII decimal # can be 0 through 00255; default = the byte count. A 3-byte length = 3L.
The response includes leading zeros.
X2#
= Priority Status for port
0 = Use Send data string command parameters (default); 1 = Use Configure receive timeout command parameters. The response includes leading zeros.
View receive timeout
ASCII (Telnet) URL Encoded (Web)
(host to processor) (host to processor)
E X! X2( X! X2(
}
* CY W %2A
E X! } X! |
CP W CY
E X! X3) X3! }
* , CF
X!
W %02A
E X! } X! |
CF W CF
E X! X1& X2) X2# X2! }
* * * * CE
X! X1&
W %2A
X! X2#
receiving timeouts. For :
E X! } X! |
CE W CE
PRELIMINARY
Response
(Processor to host)
| X2( ]
X!
CY Cpn • Cty
X2( ]
X3) X3! |
%02C CF
X! X3) X3! ]
Cpn • Cfl ,
X3) X3! ]
,
X2) X2# X2! |
%2A %2A %2A CE
X! X1& X2)
Cpn • Cce ,
X2!
:
X1& X2) X2# X2! ]
, , ,
Additional description
X!
X2(
Select serial mode for port .
X!
= 01 through 99.
X2(
For :
0 = RS-232
1 = RS-422
N Only the rear panel RS-232/422 port
can be configured. Therefore,
X3) X3!
Set flow control type with ms
X3)
between bytes. For :
H = Hardware.
S = Software.
N = None (default).
X3!
= 0000 through 0001; default = 0 ms.
Set the time that the MGP will wait for a
response before terminating the command.
X2# X2! ]
, , CE
X!
= 1.