Extron electronics MTP 15HD RS Series Setup Manual

MTP 15HD RS Series • Setup Guide
This card provides quick start instructions for an experienced installer to set up and operate any of the MTP VGA video and RS‑232 transmission
systems.
Pre-installation — RS-232 Jumper
The receiver's RS‑232 circuits are factory‑set to be one‑way, transmitter to receiver. If the system has only one
receiver, jumper JMP 1 on the main board can be set for two‑way communication as shown at right.
Installation
Step 1 — Mounting
Turn off or disconnect all equipment power sources and mount the MTP transmitter and up to eight receivers
as required.
Step 2 — Transmitter Inputs
•
Connect a computer (VGA) video source to the Input connector.
•
Connect a VGA monitor to the Monitor connector.
•
Plug an RS‑232 device into the RS‑232 port. Wire the connector as shown below.
Connected
Receive
RS-232
Transmit
Device Pins
Ground
Step 3 — TP Cables Between Units
•
Terminate a TP cable as shown at right. Connect it between the transmitter's Output port and the
receiver's Input port (both ends must match).
NOTE:
If the unit is labeled "C7," only CAT 7 cable should be used.
•
For daisy-chaining, connect up to eight TP cables between a receiver's Buffered
Output port and a daisy‑chained receiver's Input port.
Step 4 — Receiver Outputs
•
Connect a VGA monitor to the Output connector.
•
Plug an RS‑232 device into the RS‑232 port. Wire the connector as shown in step 2, above.
Step 5 — Receiver DIP Switches
•
H Sync and V. Sync switches — Set these switches up for positive sync or down for negative sync.
•
Composite Sync, (SOG), and Video switches — Set these switches as shown in the following table to output the
indicated format.
Output Format C Sync
RGBHV
RGBS
RGsB
Component*
S‑Video*
Composite*
NOTE: * Input video format must match.
•
End Unit switch — Set this switch up if either of the following is true:
• The receiver being configured is the only receiver connected to the transmitter.
• The receiver being configured is the last receiver in a daisy‑chained system.
Tx
MTP
Rx
Pins
Gnd
SOG Video
  
  
  
  
  
  
Unjumpered for
One-way (Default)
JMP3
JMP2
JMP1
Jumpered for
Two-way
RS-232
Tx Rx
INPUT MONITOR
Pins:
12345678
T568A T568B
Pin
Wire Color Wire Color
1 White-green White-orange
2 Green Orange
3 White-orange White-green
4 Blue
Blue
5 White-blue White-blue
6 Orange Green
7 White-brown White-brown
8 Brown Brown
Insert Twisted
Pair Wires
NOTE: If you are using Enhanced Skew-Free™
A/V cable, use the TIA/EIA T568A standard only.
RS-232
Tx Rx
OUTPUT
ON
1 2 3 4 5 6