Setting The [Control] - ProMinent DULCOMETER Assembly And Operating Instructions Manual

10 Setting the
User qualification: trained user, see
n
Continuous display ➨
Settings for [Channel 2]
In its 2-channel version, the controller has two measurement channels. This descrip‐
tion for [Channel 1] applies correspondingly for the settings in [Channel 2]. The pro‐
cedure for making the settings for the channel in question is identical, however the
parameters to be set may be different. Differences are pointed out and are also
described.
NOTICE!
Possible data loss
If you change measured variables in the
'Setting measured variables' on page 52 , all settings in the [Measurement] and
[Control] menus are reset to their factory settings (default values). You then have to
re-enter the settings in the
responsible for the correct set-up of the controller.
Prerequisites for set up of the [Control]:
The following settings are necessary for the [Control] set-up: If you have not yet
made the settings, do this now.
Specify the measured variables and all the necessary settings in the
–
[Measurement] menu, see Ä Chapter 8 'Setting measured variables' on page 52
Specify all the actuators planned for the control task: You can find specifications
–
for the relevant electrical connections and settings in the following menus
[Pumps], see Ä Chapter 12 'Setting the [Pumps]' on page 125
–
[Relays], see Ä Chapter 13 'Setting the [Relays]' on page 128
–
[mA outputs], see Ä Chapter 15 'Setting the [mA outputs]' on page 136
–
Actuators (regulator control elements) are, for example, metering pumps, solenoid
valves, motorised butterfly valves etc.
[Control]
Ä Chapter 4.4 'Users' qualifications' on page 21
[Control] ➨
➨ or
[Measurement] menu, see Ä Chapter 8
[Measurement] and [Control] menus. The operator is
Setting the
[Control]
[Control]
101