Removing Or Installing Arc Assembly A And B; Removing Arc Assembly A And B - IBM 950 User Manual

Step 11
Step 12

Removing or Installing ARC Assembly A and B

Note: Before you start, first see the "Connection Procedures" on page C-2.

Removing ARC Assembly A and B

Step
Step
Put two identical labels at both ends of the cable (see the two 3 s in
Figure C-10 on page C-15).
Connect the LIC11 cable to the LCB base and tighten the cable plug
retaining screws (see "Unplugging or Plugging LIC Cables" on page C-7
for details, and also 1 in Figure C-10 on page C-15).
1
Ask the network operator to deactivate the communication lines of the
ARC that you wish to unplug.
2
Unplug the ARC cable from the DTE/DCE or 3745-type connector.
When you disconnect a 3745-type connector:
a. Hold the connectors with both hands.
b. Squeeze the side levers and at the same time pull the connectors
apart with a side-to-side rocking motion.
c. Store the connecting seal with the ARC for future use.
Appendix C. Installing LCBs, ARCs, and Connecting Cables
C-17