Table of Contents
Advertisement
4. Press the ↑ key to select a digit. Press the → key to move to the next position
5. Press Enter twice to save the target service processor's phone number.
Setting the IBM 7858 Modem Connected to MPA Card (SYN)
1. Press the ↓ key until the 'CONFIG' message displays at the top of the panel.
2. Press the → key until the 'Sel Factory' message displays at the bottom of the
3. Press Enter.
4. Press the ↑ key until 3 displays.
5. Press Enter to load the predefined factory configuration 3.
6. Press the ↑ key until 'U4' displays at the top of the panel.
7. Press the → key until '9600bps V32' displays. Press Enter to validate.
8. Press the ↑ key until 'U7' displays.
9. Press the → key until 'Xon/Xoff Passed' displays. Press Enter to validate.
10. Press the ↑ key until 'U8' displays.
11. Press the → key until 'Xon / Xoff' displays. Press Enter to validate.
12. Press the ↑ key until 'U10' displays.
13. Press the → key until 'Forced on' displays. Press Enter to validate.
14. Press the ↑ key until 'U12' displays.
15. Press the → key until Follow CD displays. Press Enter twice to select this
16. Press ↓ until 'Mode' displays.
17. Press → until the message 'V25HDLC NRZIASC' displays.
18. Press Enter twice.
The modem is now in V.25 bis synchronous mode. See "Saving the Modem
Configuration" on page E-7 below.
Setting the 7858 Modem Connected to COM1 (ASYN)
1. Power OFF the modem
2. Press and hold the ↑ key while power ON the modem.
3. The modem is set to Factory 0 in AT command mode.
See "Saving the Modem Configuration" on page E-7 below.
Setting the 7858 Modem Connected to MPA Card on COM2 (ASYN)
1. Power OFF the modem
2. Press and hold the ↑ key while power ON the modem.
3. The modem is set to Factory 0 in AT command mode.
See "Saving the Modem Configuration" on page E-7 below.
E-6
3746-950: User's Guide
(↓ key can be used for backspacing).
panel.
option.
Advertisement
Table of Contents
