Installing The Driver When Installing Windows 2000 - IBM Adaptec Ultra320 SCSI User Manual

IBM Ultra320 SCSI Controller 2 User's Guide
Installing the Driver When Installing
Windows 2000
The
adpu320.sys
intallation CD and must be added during Windows 2000
installation.
1 Start your system with the Windows 2000 CD in the CD-ROM
drive.
Note: When using a CD-ROM drive to install
Windows 2000 from the bootable CD, make sure Bootable
CD support is enabled in either the system or SCSI BIOS
Setup Utility. If these options are not available, boot from
the Windows 2000 floppy disks.
2 You may see a message:
Press any key to boot from CD.
You have five seconds to press a key to boot off the CD.
3 Press F6 when this message is displayed:
Press F6 if you need to install a third-party SCSI or RAID driver...
4 After a brief delay, a message prompts you to install your
driver. Press S to specify a driver.
5 Insert the Ultra320 FMS driver floppy disk for Windows 2000
into drive A, and press Enter.
6 You are presented with a selection of driver choices. Select the
Windows 2000 driver and press Enter.
7 If you have no other controllers to add, press Enter to continue
with the Windows 2000 installation.
4-2
driver is not embedded on the Windows 2000