Specific Button Selections; Selections Using The Function Button - IBM 950 User Manual

Specific Button Selections

Functions 0, 1, and 2 are enabled by the Function button on the display panel, and
also display automatically when you press the corresponding control panel buttons
(General IML, CBSA IML, and CBSP Dump). Functions 3 to 8 are also enabled
by the Function button on the display panel.
0 - General IML
Resets and performs an IML for all 3746 processors.
Use this function after one of the following:
1 - CBSA IML with Diags
Runs a diagnostics and IML for the CBSA (Controller Bus and Service Adapter).
Note: Mainly used by an IBM service representative.
2 - CBSP Dump
Transfers a CBSP dump to the MOSS-E on the service processor disk.
Note: Mainly used by the an IBM service representative.

Selections Using the Function Button

To select functions 3-8, perform the following actions:
1. Press Function repeatedly until the number of the function that you want
2. Press Validate to start the function.
3 - General IML with Diags
Performs an IML and diagnostics for all 3746 processors.
Note: Mainly used by an IBM service representative.
4 - CBSA IML
Performs an IML for the CBSA (Controller Bus and Service Adapter).
Note: Mainly used by an IBM service representative.
5 - Panel Test
Runs a diagnostics of the control panel. Before you can use this function, make
sure that Service Mode 1 is selected (see "Service Mode" on page A-3).
Note: Mainly used by an IBM service representative.
A-2
3746-950: User's Guide
Attention
You must perform function "8 - CBC/ESCC logical disconnection" on page A-3
before running function 0.
Power ON.
In an emergency, when the MOSS-E function Perform a general IML does not
run. For more information, see "Activation and IML from the 3746 Operator
Control Panel" on page B-9.
displays on the control panel.