Servicing the IBM ServeRAID M5015 SAS/SATA II Controllers –Installing the M5014 and M5015 Controllers
Installing the ServeRAID M5000 Series Battery Assembly on the ServeRAID
M5015 Controller
The battery assembly mounts directly to the ServeRAID M5015 controller using a
small board-to-board connector (daughtercard).
Figure 2 displays the bottom view and the top view of the card. (The "top" side is the
side that is visible after the battery assembly is installed on the RAID controller.)
Note that this unit combines a battery pack with a daughtercard.
Figure 2 –Views of the ServeRAID M5000 Series Battery Assembly
1 - J4 battery pack harness connector
2 - J5 board-to-board connector
3 - J2 connector
4 - Battery pack harness
October 2009
30
XW5196r110.pdf