Table of Contents
Advertisement
Chapter 10. Using DCAF with an APPN-Attached Remote
|
Workstation
|
Token-Ring
LAN
MAC ADDRESS=
400000502144
APPN/Attached Workstation
PU=CPCTRL1
LU=CTRLAPPN
Figure 10-1. APPN Remote Workstation
Configuring a Target Service Processor
Copyright IBM Corp. 1992, 2000
3746
3745
Virtual Route
900NN
TIC3
SAP=08
APPN-NETWORK
This chapter describes how to configure a DCAF session for controlling the service
processor (see Figure 10-1). If you have more than one target service processor,
you must respect the parameter value matching rules in Appendix D, "Configuration
for a Two-Target Remote Workstation."
Use the worksheets in the 3745/3746 Planning Series: Management Planning,
GA27-4239 to record the necessary parameter values described in this section.
This section describes the following:
The MOSS-E configuration for a DCAF link to the communication controller.
The MOSS-E parameters required for use in the controlling workstation.
Service
LAN
3746
3745
900NN
Service Processor
PU=MOSSNMVT
LU=DCAFAPPN
10-1
Advertisement
Table of Contents
