Installing A Backup Service Processor - IBM 950 User Manual

Step
Step
Step
Step

Installing a Backup Service Processor

If the active service processor fails, replace it with the backup service processor as
follows:
Step
Step
Step
Step
Step
Step
Step
Step
2-8
3746-950: User's Guide
5. Click Change Management.
6. Insert the CD with the service processor installation code into the
CD-ROM.
7. Double-click Restore SP (&NNP) LIC on non-active version.
8. Follow the prompts.
Attention
Make sure the microcode and configuration levels are the same in both the
primary and the backup service processor.
1. Power OFF the active service processor.
2. Verify that the backup service processor is powered OFF.
3. Disconnect the active (failed) service processor from the token-ring LAN.
4. If necessary, disconnect any RSF modem or telephone lines.
5. Connect the backup service processor to the token-ring LAN.
6. If necessary, connect the backup service processor to any RSF modem
or telephone lines.
7. Check that the service processor installation diskette is not in the backup
service processor disk drive.
8. Power ON the backup service processor.