Table of Contents
Advertisement
Chapter 13. Using DCAF with an APPC LAN-Attached
|
Remote Workstation
|
Configuring a Target Service Processor
Copyright IBM Corp. 1992, 2000
DCAF
LAN-Attached
Workstation
Figure 13-1. APPC Service LAN-Attached Remote Workstation
This chapter describes how to configure a DCAF session for controlling a target
service processor (see Figure 13-1). If you have more than one target service
processor, you must respect the parameter value matching rules given in
Appendix D, "Configuration for a Two-Target Remote Workstation."
Use the worksheets in the 3745/3746 Planning Series: Management Planning,
GA27-4239 to record the necessary parameter values described in this section.
This section describes the following:
The MOSS-E configuration for a DCAF link to the communication controller.
The MOSS-E parameters required for use in the controlling workstation.
Parameter Values that Must Be the Same
Table 13-1 on page 13-2 gives the sets of MOSS-E parameters that must have the
same value in both the remote workstation and the target service processor.
3745
3746
9x0
Service
LAN
Service
Processor
13-1
Advertisement
Table of Contents
