Unplugging Or Plugging Tic3 Cables - IBM 950 User Manual

Figure C-4. 3746-950 LCB Locations in a Base Frame and a Controller Expansion

Unplugging or Plugging TIC3 Cables

Note: Before you start, first see the "Connection Procedures" on page C-2.
There are two types of cable for a TIC3:
If you are unplugging an attachment cable, start at step 1 on page C-5. Otherwise,
see the following step references for different types of cable:
C-4
3746-950: User's Guide
After you have located an LCB, see "Removing or Installing ARC
Assembly A and B" on page C-17.
Token-ring shielded twisted pair (STP) cable, only available from IBM.
Untwisted pair (UTP) cable, through a Token-Ring MAU Media Filter,
unavailable from IBM.
Attention
This section does not apply to TIC3 cables for an Ethernet bridge or for a
Service Processor Access Unit (SPAU).
Plugging in an attachment cable, step 1 on page C-5.
Unplugging a UTP cable, step 1 on page C-5.