Removing Or Installing Arc Assembly A; Arc Assembly A And B - IBM 3745 Series Connection And Integration Manual
Communication controller/nways multiprotocol controller
Hide thumbs
Also See for 3745 Series:
- Hardware maintenance reference (712 pages) ,
- Maintenance information reference (595 pages) ,
- Problem determination manual (387 pages)
Table of Contents
Advertisement
Removing or Installing ARC Assembly A
BEFORE BEGINNING - - - - " ' - - - - - , - - - - - - - - - - - - - ,
Do the "Starting Connection Tasks" on page 3-2 before beginning this task.
Use the following procedure to install or remove the active remote connector (ARC)
assembly A:
Step
1
Identify the ARC assembly A
The ARC assembly A has a permanently attached cable which has a
connector that corresponds to the physical interface of the ARC:
Note: The ARC color is light grey.
ARC Assembly A
ARC Assembly B
Figure 3-13. ARC Assembly A and B
The cables are available in a range of cable lengths (for more details of
available cable lengths, refer to the Migration and Planning Guide,
GA33-0183).
3-18
3745 All Models
&
3746-900: CIG
,I
0 ' . " ' , '
..
o
Advertisement
Table of Contents
