Switch Settings For Ibm Modems 5841, 5842, And 5853 - IBM 950 User Manual

Switch Settings for IBM Modems 5841, 5842, and 5853

IBM 5841 Modem
Set the modem switches of the remote console as follows:
1. Set back panel DIP switches SW7 and 8 DOWN, all others UP.
2. Set all front panel switches OUT.
Set the modem switches of the 3745 as follows:
1. Set back panel DIP switches SW7 and 8 DOWN, all others UP.
2. Set all front panel switches OUT.
IBM 5842 Modem
Set the switches at the remote console site as follows:
1. Set back panel DIP switches SW7 and 8 DOWN, all others UP.
2. Set front panel switches FS IN, all others OUT.
Set the switches at the 3745 site as follows:
1. Set back panel DIP switches SW7 and 8 DOWN, all others UP.
2. Set front panel switches FS IN, all others OUT.
IBM 5853 Modem
Set the switches at the 3745 site as follows:
1. Set back panel DIP switches to UP.
2. Set front panel switches FS IN, all others OUT.
Set the switches at the remote console site as follows:
1. Set back panel DIP switches to UP.
2. Set front panel switches FS IN, all others OUT.
Note: Before you set any modem configurations, make sure that both modems
have been initialized and then do the following:
1. Push in all the front panel switches.
2. Turn power ON and wait five seconds.
3. Turn power OFF.
4. Set the front panel switches as described above.
5. Turn power ON again.
E-2
3746-950: User's Guide