Unplugging Aui Cables; Plugging Aui Cables - IBM 950 User Manual

Unplugging AUI Cables

Note: Before you start, first see the "Connection Procedures" on page C-2.
Step
Step
Step
Step

Plugging AUI cables

Step
Step
Step
C-8
3746-950: User's Guide
Important: read this before you start
Please consult the Safety Information, GA33-0400 before you install any AUI
cables. Also, please take into consideration the following:
To attach your controller to an Ethernet LAN, the SQE TEST switch on the
Access Unit must be set to ENABLE. Otherwise, Ethernet LAN operations
may be interrupted.
If you need to replace an AUI cable with a 10BASE-T cable, contact your
IBM service representative.
1
To unplug an AUI cable, first ask the network operator to deactivate the
appropriate line.
2
Unlock the AUI connector latch by pushing it to the left.
Note: The locking latch is sometimes difficult to move.
3
Pull out the plug.
4
Close and lock the door with the key.
1
Make sure that all cables are correctly labeled at both ends. Repeat
this step for every AUI that you need to plug in.
2
Locate a port that matches the label on the cable.
3
Slide the latch to the left.